A fully insulated Rain Suit for ArmX1.
ARM POST 3/4IN – STICK OUT 40MM / 1.5IN
Compatible with major plates on the market. Cartoni, Sachtler, Manfrotto, etc…
Additional MiniClamp for Zen PRO Core, designed to accommodate rods measuring 16mm (0.625 inches). SKU: 000010272
Compatible arms:
– SmartSystem Arm X1
– PRO® GPI® Titan® and Atlas® Arms
– FlowCine® XArm®
– Tiffen steadicam® arms with 5/8 arm post
– SmartSystem Arm X1
– PRO® GPI® Titan® and Atlas® Arms
– FlowCine® XArm®
– Tiffen steadicam® arms with 5/8 arm post
V-Lock plate addon kit for SmartSystem monitor, It includes a jumper cable from DTAP to monitor ...
Universal Vest Knobs M6 with rounded tips. Stainless steel knobs with round tips to avoid dent on Industry standard mating block.
Monitor rods with clamp designed to fit Matrix sled posts (1.57" / 40mm)The kit include two 15mm carbon fiber rods with a lenght of 200mm.The center to center distance between rods is 100mm (Matrix sled standard)
With this kit, it is possible to transform the standard ArmX1 Arm Post into a free-spinning friction-less Arm Post ...
Vlock plate addon kit for SmartSystem monitors: SM7-3K and SM7-3K-Z
Professional gimbal with dual bearings configuration for every axis
Reduce to zero the play of the yaw axis when the in-built Ronin2 locking system is engaged.
Engineered to be lightweight as ultra stable.
Equipped with Gimbal lock (including retaining pin)
Plastic Gimbal
5/8" pin to balance your Sled
Support for vest
Support for Arm
Plastic Gimbal
5/8" pin to balance your Sled
Support for vest
Support for Arm
Dual battery pack for 3Studs Batteries with integrated electronics ...
ARM POST 5/8IN – STICK OUT 190MM / 7.5IN
ARM POST 5/8IN – STICK OUT 140MM / 5.5IN
ARM POST 3/4IN – STICK OUT 140MM / 5.5IN
ARM POST 1/2IN – STICK OUT 40MM / 1.5IN
Universal camera plate compatible with most sleds on the market. Equipped with safety locking screws. Total compatibility with VersaHead. Length: 16inches (406mm), Weight: 9.7 oz (275 gr.) ...
Universal camera plate compatible with most sleds on the market. Equipped with safety locking screws.
U-Bracket designed to be compatible with ARRI® Artemis2/Trinity2. It let you increase the distance from the arm post and the Sled handle giving to you more headroom to install your preferred monitor on this last one.
It minimize the oscillation of Zen due to improper installation granting a more stable behavior especially on low mode.
It can be used to power the following products
Monitor SM7-3K
Monitor SM7-3K-Z
SmartCAM Zen
as well as every product that follows ARRI Standard (i.e. negative/ground on pin defined by red dot on the female socket)
Monitor SM7-3K
Monitor SM7-3K-Z
SmartCAM Zen
as well as every product that follows ARRI Standard (i.e. negative/ground on pin defined by red dot on the female socket)
SmartSystem produces professional Stabilizers, X1 Arm, advanced Motion Control for Film Makers and Video Makers, Camera Slider, Camera Dollies ...
