Sale
Replacement Pull Pin for \LX and Zephyr/Aero30 Vest.
Press fit. 1x supplied. *You will need a mechanical press or vice to install this item.
Press fit. 1x supplied. *You will need a mechanical press or vice to install this item.
12V Camera Power Cable for Clipper 312/324 (078-7351-01)...
The official Steadicam Baseball Cap ...
Longer handle for Steadicam M1 gimbal, adding an additional 1" to standard length.
Suitable for 3/4" Arm posts. *Allow 7 days for dispatch.
Suitable for 3/4" Arm posts. *Allow 7 days for dispatch.
Arm Hanger Pin for use with the Steadicam Padded Docking Bracket. Attaches with 1/4-20" thread. Now with stainless steel pin, and suitable for smaller diameter arm hollow posts.
Full Size Socket block for Steadicam vests, vehicle mounts etc.
Replacement pivot shaft for the Flyer, Zephyr and Scout Gimbal.
Bearings for the pivot shaft (each) - There are 2x in the handle.
Bearings for the pivot shaft (each) - There are 2x in the handle.
Dust cap for the Steadicam Aero gimbal tilt adjusters. Aero Gimbal Dust Cap ( 4 piece ) - MSC-150268
Exovest Replacement Straps 815-7888
Small Socket Block for 801-7804 for: Aero15; Pilot, Merlin Vest ...
Lens height above Steadicam arm typically 575mm (22 5/8 inch). With the new Upside-Down adapter the Lens height is 395mm / 15 1/2 inches
Powering your stabilized handheld video rig just got easier with the Dual V-Lock Battery Base for M1 Stabilizer Kit. This base attaches to the bottom of the M1's post easily. Connect up to two V-mount batteries. The base holds 12 and 24V batteries.
Shadow Mini Docking Bracket with 3/4", 5/8" & 1/2" Pins
REAR WAIST - Part Nr. 815-7818
801-7291 is a kit for adaptation to an arm and vest upgrade ...
Extension Monitor/Battery Rods Ideal for mounting accessories under the stage, such as Monitors for low mode, or MDR systems.
Replacement camera mounting pin for camera mounting plate assembly (601-7412 and 802-7417). The pin screw is compatible with Clipper 2, Clipper, Vector and Archer_2S.
Compatible withClipper 2, Clipper, Vector, Archer_2S
Compatible withClipper 2, Clipper, Vector, Archer_2S
The Steadicam Zephyr Power Cable for Red Epic & Scarlet provides power from your Steadicam Zephyr or Archer camera stabilizer to your attached camera. The cable weighs about 1.6 oz and is 15" long.
Arm Post -Size: 12" to 5/8" Top - 800-7204-06
Arm Post - Size: 12" 5/8" post to 3/4" top - 800-7204-07
Arm Post - Size: 12" to 1/2" Top - 800-7204-05
GIMBAL PIVOT SHAFT - 602-7116-01
GIMBAL PIVOT SHAFT - BRG-013170
Replacement locking knob for Aero Gimbal clamp. Pull and twist action
We offer accessories for all rig systems from Steadicam. Ask us if you cannot find a part for your system in our shop. As an official dealer for Steadicam products, we offer the complete range.
